12 Cast Modifications
| 1) Gather tools and strip your cast
Modification tools: flat head screwdriver, gloves, cast saw, indelible pencil, outside calipers, surforms, loop tool. |
|
| 2) Draw the trimlines on your cast. Mark the reference points – axilla, clavicle, and spine of the scapulaStep back and look at the model. Don’t make any modifications yet.
Position the mold so that the anterior wall is facing toward the ceiling. Consider how the shape of the model matches your patients shoulder as if they were lying supine on a table. |
 |
| 3) Start the modifications by placing the mold in the vice with the medial wall parallel to the ground. The location of the proximal lateral trimline is about 1 ½”-2” above the level of the axilla. Use the full round surform to cut a depth of ¾ or the full depth of the round surform at the proximal lateral trimline. The depth depends on the compressibility of the soft tissue. |  |
Trimlines (These vary, depending on the level of amputation and the activity level)
| Axilla trimline | Anterior trimline | Superior/lateral | Posterior | |
| Elbow Disarticulation
(Type I) |
high enough for socket stability | encompass the humerus in its entirety, but does not impede ROM | 1/2” proximal to the level of the axilla or at the axillary level | encompass the humerus in its entirety; |
| Medium-long transhumeral
(Type II) |
at pectoralis and teres tendon/muscle | just medial to the delto-pectoral groove with enough flaring | 11/2”-2” proximal to the level of the axilla | extension over the scapula for socket stability |
| Short Transhumeral
(Type 3) |
pectoralis and teres tendons/muscles in contact with the socket, extensions down three ribs on the chest wall. | to prevent edge pressure; does not impede ROM.
Short Transhumeral: at least 2 cm or 3/4” medial to the delto pectoral groove |
11/2”-2” proximal to the level of the axilla | include as much of the scapula as possible |
| 4) Flatten the posterior wall to the depth of the finger indentations. Maintain the plane of the scapula. |  |
| 5) Smooth the medial wall. |  |
| 6) Shave the proximal portion of the cast down the groove. |  |
| 7) Remove plaster from corners and smooth the transition from posterior to lateral and anterior to lateral. |  |
Step back and evaluate each perspective of the mold. Consider the underlying anatomy.
| 8) Add plaster to blend the anterior trimline to the axilla and the posterior trimline to the axilla.
|
 |
| Create a slight reverse curve in the axilla. |  |
| 9) Shape the anterior stabilizer.The deepest portion of this is at the deltopectoral groove – medial to the apex of the head of the humerus and about 1-2” distal to the clavicle. This shape is 3-d shaped or fossa-shaped. |  |
| 10) Smooth the mold. |  |
Test Socket Fabrication
| Thermoform the plastic over the mold. |  |
| Avoid wrinkles at the shape transitions. |  |
| Get a good seal on the platen. |  |
| Trim it out, smooth it and drill a pull hole. |  |